Laing Table Controller series (LTC)
LTC mains operation
Laing table controller in mains mode.
230V or 115V AC
LTCB battery operation
Laing table controller powered by batteries.
97 Wh battery. Minimal standby power consumption, making it ready for use even after many months in standby mode. Same performance as the mains controller.
LTCD DC
Laing table controller in DC mode.
10V to 36V DC. Same performance as the mains controller.
Controller for 1 to 4 drives
Depending on the version, the controller can control up to 4 drives synchronously.
Easy configuration
With an easy-to-use software tool, a configuration file is created, which is then saved in the controller and can be loaded into additional controllers within seconds with the downloader. Of course, the controller can also be delivered preconfigured.
Powerful collision detection
In addition to the standard current-based collision detection, there is an optional gyro and gravity sensor. These sensors not only allow reliable detection of a collision, but also ensure that the table can never fall over.
Communication via BLE or WiFi
The controllers are optionally upgraded with these modules, to communicate for example with a PC or smartphone. The ModBus interface is included in every controller.
FAQ
Here you will find answers to frequently asked questions about our controllers, such as areas of application, deployment and more.
All Laing controllers are able to control DC drives with 24 V and one or two Hall outputs.
Laing controllers can be used in a variety of ways. Possible areas of application include office applications, industrial applications, trucks, boats, motorhomes, home applications and much more.
The Laing controllers can be configured using a programming cable via our LTC Wizard. All parameters can be set here.
In most cases, the service can be provided by Laing online, for example via TeamViewer. All movement-relevant parameters can be viewed and adjusted via the service app. This makes it possible to identify and fix problems that arise as a whole as a result of the application.
If DC drives with 24 V and one or two Hall outputs are used, controllers from other manufacturers can easily be replaced by Laing controllers.
The Laing controllers of all series have ETL approval for USA and Canada and CE for Europe.
Laing controllers are equipped with Modbus RTU as standard. In addition, the Laing PLC adapter can be used to connect Laing controllers to a higher-level controller.